Dell S4810 - Speed (Management Interface)

Version 8.3.1.0 Supported on LC-EH-GE-50P or the LC-EJ-GE-50P cards.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage
Information
This command is found on the 10/100/1000 Base-T Ethernet interfaces.
When you enable auto, the system performs an automatic discovery to determine
the optics installed and configure the appropriate speed.
When you configure a speed for the 10/100/1000 interface, confirm the
negotiation auto command setting. Both sides of the link must have auto-
negotiation either enabled or disabled. For speed settings of 1000 or auto, the
software sets the link to auto-negotiation and you cannot change that setting.
NOTE: Starting with Dell Networking OS version 7.8.1.0, when you use a
copper SFP2 module with catalog number GP-SFP2-1T in the S25P model of
the S-Series, you can manually set its speed with the speed command. When
you set the speed to
10 or 100 Mbps, you can also use the duplex command.
Related
Commands
duplex (10/100 Interfaces) — configures duplex mode on physical interfaces with
the speed set to 10/100.
negotiation auto — enables or disables auto-negotiation on an interface.
speed (Management interface)
Set the speed for the Management interface.
S4810
Syntax
speed {10 | 100 | 1000 | auto}
To return to the default setting, use the no speed command.
Parameters
10 Enter the keyword 10 to set the interface’s speed to 10 Mb/s.
100 Enter the keyword 100 to set the interface’s speed to 10/100
Mb/s.
1000 Enter the keyword 1000 to set the interface to auto-
negotiate its speed.
auto Enter the keyword auto to set the interface to auto-
negotiate its speed.
Interfaces
799