Dell S4810 - Queue Egress

queue egress
Assign a WRED Curve to all eight egress Multicast queues or designate the percentage for the Multicast
bandwidth queue.
S4810
Syntax
queue egress multicast linecard {slot number port-set number |
all} [wred-profile name | multicast-bandwidth percentage]
To return to the default, use the no queue egress multicast linecard
{
slot number port-set number | all} [wred-profile name |
multicast-bandwidth
percentage] command.
Parameters
linecard
number
Enter the keyword linecard then the line card slot number.
port-set
number
Enter the keywords port-set then the line card’s port pipe.
The range is from 0 or 1.
all Enter the keyword all to apply to all line cards.
wred-profile
name
(OPTIONAL) Enter the keywords wred-profile then your
WRED profile name in character format (16 character
maximum). Or use one of the pre-defined WRED profile
names.
Pre-defined Profiles: wred_drop, wred-ge_y, wred_ge_g,
wred_teng_y, wred_teng_g.
multicast-
bandwidth
percentage
(OPTIONAL) Enter the keywords multicast-bandwidth
then the bandwidth percentage. The range is from 0 to
100%.
Defaults none
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.8.10
Introduced on the S4810.
Version 7.5.1.0 Added support for multicast-bandwidth.
Version 7.4.1.0
and 6.5.3.0
Introduced on the E-Series.
1362
Quality of Service (QoS)