Dell S4810 - Clear Host

Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Introduced on the S-Series and Z-Series.
Usage
Information
Use this command to create a mapping between a host name server and its IP
addresses for a specific VRF.
Example
Dell(conf)#ip host vrf jay dell 1.1.1.1
clear host
Removes one or all dynamically learned host table entries for a specific VRF.
S4810
Syntax
clear host [vrf vrf-name] {* | host-name}
Parameters
vrf vrf-name (Optional) Enter the key word vrf and then the name of the
VRF to delete dynamically learned host table entries
corresponding to that VRF.
host-name Enter the name of the host corresponding to which you
want to delete the dynamically learnt host table entries.
* Enter * to delete all host table entries.
Defaults None
Command
Modes
EXEC
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Introduced on the S-Series and Z-Series.
Usage
Information
Use this command to delete one or all dynamically learned host table entries
corresponding to a specific VRF.
Example
Dell#clear host vrf jay dell
Dell#clear host vrf jay *
640
Dynamic Host Configuration Protocol (DHCP)