Dell S4810 - Show Fips Status; Show Ip Ssh

show fips status
Displays the status of the FIPS mode.
S4810
Syntax
show fips status
Defaults None
Command
Modes
EXEC
Example
Dell #show fips status
FIPS Mode: Enabled
Dell#
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.1(0.0) Introduced on the Z9000.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
show ip ssh
Display information about established SSH sessions
S4810
Syntax
show ip ssh
Defaults none
Command
Modes
EXEC
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.1(0.0) Introduced on the Z9000.
654
FIPS Cryptography