Dell S4810 - Mep Cross-Check Start-Delay

Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.3.1.0 Introduced on the S-Series.
mep cross-check start-delay
Configure the amount of time the system waits for a remote MEP to come up before the cross-check
operation is started.
S4810
Syntax
mep cross-check start-delay number
Parameters
start-delay
number
Enter a start-delay in seconds. The range is from 3 to 100
seconds.
Defaults 3 ccms
Command
Modes
ETHERNET CFM
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.3.1.0 Introduced on the S-Series.
172
802.1ag