Dell S4810 - Ip Access-List Standard

Usage
Information
The order option is relevant in the context of the Policy QoS feature only. For
more information, refer to the Quality of Service chapter of the Dell Networking OS
Configuration Guide.
The software cannot count both packets and bytes, so when you enter the count
byte options, only bytes are incremented.
Related
Commands
ip access-list standard — configures a standard ACL.
permit — configures a permit filter.
ip access-list standard
Create a standard IP access list (IP ACL) to filter based on IP address.
S4810
Syntax
ip access-list standard access-list-name
To delete an access list, use the no ip access-list standard access-
list-name command.
Parameters
access-list-
name
Enter a string up to 140 characters long as the ACL name.
Defaults All IP access lists contain an implicit “deny any,” that is, if no match occurs, the
packet is dropped.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version
8.3.10.0
Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Increased the name string to accept up to 140 characters.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
216
Access Control Lists (ACL)