Dell S4810 - Crypto Ipsec Policy

Usage
Information
• Both sides of the link must specify the same transform set.
• You can create up to 64 transform sets.
Example
Dell(conf)#int ten 0/4
Dell(conf-if-te-0/4)#ipv6 address 200:1::/64 eui64
Dell(conf)#int ten 0/6
Dell(conf-if-te-0/6)#ipv6 address 801:10::/64 eui64
crypto ipsec policy
Create a crypto policy used by ipsec.
S4810
Syntax
crypto ipsec policy name seq-num ipsec-manual
To delete a crypto policy entry, use the no crypto ipsec policy name seq-
num
ipsec-manual command.
Parameters
name Enter the name for the crypto policy set.
seq-num Enter the sequence number assigned to the crypto policy
entry.
Defaults none
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.2) Introduced on the Z9000, S4810, and S4820T.
Usage
Information
This command creates a crypto policy entry and enters the crypto policy
configuration mode for configuring the flow parameters.
Example
Dell(conf)#crypto ipsec policy West 10 ipsec-manual
Dell(conf-crypto-policy)#
Internet Protocol Security (IPSec)
831