Dell S4810 - Redistribute Isis

pre-Version
6.2.1.1
Introduced on the E-Series.
Usage
Information
To redistribute the default route (0.0.0.0/0), configure the default-information
originate command.
Related
Commands
default-information originate — generates a default route for RIP traffic.
redistribute isis
Redistribute routing information from an IS-IS instance.
S4810
Syntax
redistribute isis [tag] [level-1 | level-1-2 | level-2] [metric
metric-value] [route-map map-name]
To disable redistribution, use the no redistribute isis [tag] [level-1 |
level-1-2 | level-2] [metric
metric-value] [route-map map-name]
command.
Parameters
tag (OPTIONAL) Enter the name of the IS-IS routing process.
level-1 (OPTIONAL) Enter the keywords level-1 to redistribute
only IS-IS Level-1 routes.
level-1-2 (OPTIONAL) Enter the keywords level-1-2 to redistribute
both IS-IS Level-1 and Level-2 routes.
level-2 (OPTIONAL) Enter the keywords level-2 to redistribute
only IS-IS Level-2 routes.
metric metric-
value
(OPTIONAL) Enter the keyword metric then a number as
the metric value. The range is from 0 to 16.
route-map
map-name
(OPTIONAL) Enter the keywords route-map then the name
of a configured route map.
Defaults Not configured.
Command
Modes
ROUTER RIP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant FTOS Command Line Reference Guide.
The following is a list of the FTOS version history for this command.
1406
Routing Information Protocol (RIP)