Dell S4810 - Show Ip Flow

Field Description
First-Hop Displays the first hop IP address.
Mac-Addr Displays the MAC address.
Port Displays the egress-port information.
VId Displays the VLAN ID. If no VLAN is assigned, zero (0) is
listed.
EC Displays the number of ECMP paths.
Example
Dell#show ip fib stack-unit 0
Destination Gateway First-Hop Mac-Addr
------------------------------------------------------
10.10.10.10/32 Direct, Nu 0 0.0.0.0 00:00:00:00:00:00
Port VId EC
-------------
BLK HOLE 0 0
Dell>
Related
Commands
clear ip fib stack-unit — clear FIB entries on a specified stack-unit.
show ip flow
Show how a Layer 3 packet is forwarded when it arrives at a particular interface.
S4810
Syntax
show ip flow interface interface {source-ip address
destination-ip address} {protocol number [tcp | udp]} {src-port
number destination-port number}
Parameters
interface
interface
Enter the keyword interface then one of the following
interface keywords.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
source-ip
address
Enter the keywords source-ip then the IP source address
in IP address format.
destination-ip
address
Enter the keywords destination-ip then the IP
destination address in IP address format.
IPv4 Routing
895