Dell S4810 - Distribute-List out

Related
Commands
• distribute-list out — suppresses networks from being advertised in updates.
• redistribute — redistributes routes from one routing domain to another routing
domain.
distribute-list out
Suppress network prefixes from being advertised in outbound updates.
S4810
Syntax
distribute-list prefix-list-name out [connected | bgp as number
| ospf process-id | rip | static]
To return to the default values, use the no distribute-list prefix-list-
name out [bgp as number connected | ospf process-id | rip |
static]
command.
Parameters
prefix-list-
name
Specify the prefix list to filter prefixes in routing updates.
connected (OPTIONAL) Enter the keyword connected for directly
connected routing process.
ospf process-id (OPTIONAL) Enter the keyword ospf then the OSPF
process-ID number. The range is from 1 to 65535.
bgp as number (OPTIONAL) Enter the BGP then the AS Number. The range is
from 1 to 65535.
rip (OPTIONAL) Enter the keyword rip for RIP routes.
static (OPTIONAL) Enter the keyword static for user-configured
routing process.
Defaults Not configured.
Command
Modes
• ROUTER ISIS (for IPv4)
• CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6 (for IPv6)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
976
Intermediate System to Intermediate System (IS-IS)