Dell S4810 - Redundancy Reset-Counter

Parameters
lacp Enter the keyword lacp to make LACP hitless.
xstp Enter the keyword xstp to invoke hitless STP (all STP modes
— MSTP, PVST+, RSTP, and STP).
Default Disabled
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on the C-Series.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the E-Series.
Related
Commands
• show lacp — displays the lacp configuration.
• show redundancy — displays the current redundancy configuration.
redundancy reset-counter
Reset failover counter and timestamp information displayed in the show redundancy command.
S4810
Syntax
redundancy reset-counter
Default Not configured.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
High Availability (HA)
705