Dell S4810 - Fip-Snooping Enable; Fip-Snooping Fc-Map

Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
fip-snooping enable
Enable FIP snooping on all VLANs or on a specified VLAN.
S4810
Syntax
fip-snooping enable
To disable the FIP snooping feature on all or a specified VLAN, use the no fip-
snooping enable command.
Defaults FIP snooping is disabled on all VLANs.
Command
Modes
• CONFIGURATION
• VLAN INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
Usage
Information
The maximum number of FCFs supported per FIP snooping-enabled VLAN is four.
The maximum number of FIP snooping sessions supported per ENode server is 16.
fip-snooping fc-map
Configure the FC-MAP value FIP snooping uses on all VLANs.
S4810
Syntax
fip-snooping fc-map fc-map-value
To return the configured FM-MAP value to the default value, use the no fip-
snooping fc-map command.
FCoE Transit
663