Dell S4810 - Dns-Server; Domain-Name

Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on the C-Series and S-Series.
dns-server
Assign a DNS server to clients based on address pool.
S4810
Syntax
dns-server address [address2...address8]
Parameters
address Enter a list of DNS servers that may service clients on the
subnet. You may list up to eight servers, in order of
preference.
Defaults none
Command
Modes
DHCP <POOL>
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on the C-Series and S-Series.
domain-name
Assign a domain to clients based on the address pool.
S4810
Syntax
domain-name name
Parameters
name Give a name to the group of addresses in a pool.
618
Dynamic Host Configuration Protocol (DHCP)