Dell S4810 - Debug Ip Udp-Helper

debug ip udp-helper
Enable UDP debug and display the debug information on a console.
S4810
Syntax
debug ip udp-helper
To disable debug information, use the no debug ip udp-helper command.
Defaults Debug disabled.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Pre-version
8.3.7.0
Introduced on the E-Series ExaScale.
Example
Dell#debug ip udp-helper
UDP helper debugging is on
01:20:22: Pkt rcvd on Gi 5/0 with IP DA (0xffffffff) will be
sent on Gi 5/1 Gi 5/2
Vlan 3
01:44:54: Pkt rcvd on Gi 7/0 is handed over for DHCP
processing.
Related
Commands
ip udp-broadcast-address — configures a UDP IP address for broadcast.
ip udp-helper udp-port — enables the UDP broadcast feature on an interface.
show ip udp-helper — displays the configured UDP helper(s) on all interfaces.
Interfaces
823