Dell S4810 - Proxy-Gateway Peer-Timeout

Example
Dell(conf)#vlt-domain 1
Dell(conf-vlt-domain)#proxy-gateway lldp
Dell(conf-vlt-domain-proxy-gw-lldp)#peer-domain-link port-
channel 20 exclude-vlan 3
proxy-gateway peer-timeout
Configure the proxy-gateway VLT peer timeout value.
S4810
Syntax
[no] peer-timeout value
Parameters
value Enter the timeout value in seconds. The range is from 1 to
65535. The default is infinity.
Command
Modes
VLT DOMAIN PROXY GW LLDP
Command
History
Version 9.4(0.0) Introduced on the S4810, S4820T, S6000, Z9000, and MXL
Switch.
Usage
Information
In a square VLT topology with only one link connecting remote peers, a node must
stop sending its VLT peer MAC address ("vlt-peer-mac transmit" enabled) when the
VLT peer is down. If you configure this time out interval, it will keep sending its
peer's MAC address until the timer expires.
Example
Dell(conf-vlt-domain-proxy-gw-lldp)# peer-timeout 5
vlt-peer-mac transmit
Configures a peer to sent its VLT peer's MAC address along with its LLDP TLV.
S4810
Syntax
[no] vlt-peer-mac transmit
Command
Modes
VLT DOMAIN PROXY GW LLDP
Command
History
Version 9.4(0.0) Introduced on the S4810, S4820T, S6000, Z9000, and MXL
Switch.
1714
VLT Proxy Gateway