Dell S4810 - Show Ip Route Summary

pre-Version
6.1.1.0
Introduced on the E-Series.
Example
Dell#show ip route list test
Codes:C- connected, S - static, R - RIP,
B- BGP, IN - internal BGP, EX - external BGP,LO -
Locally Originated,
O- OSPF, IA - OSPF inter area, N1 - OSPF NSSA external
type 1,
N2- OSPF NSSA external type 2, E1 - OSPF external type 1,
E2- OSPF external type 2, i - IS-IS, L1 - IS-IS level-1,
L2- IS-IS level-2, IA - IS-IS inter area, * - candidate
default,
>- non-active route, + - summary route
Gateway of last resort is not set
Destination Gateway Dist/Metric Last Change
----------- ------- ----------- -----------
R 2.1.0.0/24 via 2.1.4.1, Gi 4/43 120/2 3d0h
R 2.1.1.0/24 via 2.1.4.1, Gi 4/43 120/2 3d1h
R 2.1.2.0/24 via 2.1.4.1, Gi 4/43 120/1 3d0h
R 2.1.3.0/24 via 2.1.4.1, Gi 4/43 120/1 3d1h
C 2.1.4.0/24 Direct, Gi 4/43 0/0 3d1h
Related
Commands
ip prefix-list — enters CONFIGURATION-IP PREFIX-LIST mode and configures a
prefix list.
show ip prefix-list summary — displays a summary of the configured prefix lists.
show ip route summary
View a table summarizing the IP routes in the switch.
S4810
Syntax
show ip route summary
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
IPv4 Routing
907