Dell S4810 - Pool; Show Ip Dhcp Binding

pool
Create an address pool.
S4810
Syntax
pool name
Parameters
name Enter the address pool’s identifying name.
Defaults none
Command
Modes
DHCP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.2.1.0 Introduced on the C-Series and S-Series.
show ip dhcp binding
Display the DHCP binding table.
S4810
Syntax
show ip dhcp binding
Defaults none
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
624
Dynamic Host Configuration Protocol (DHCP)