Dell S4810 - Trust

Pre-Defined WRED
Profile Name
Minimum
Threshold
Maximum
Threshold
wred_drop 0 0
100
wred_ten_y 467 4671 100
wred_ten_g 467 4671 50
wred_fortyg_y 467 4671 50
wred_fortyg_g 467 4671 25
Related
Commands
wred-profile — creates a WRED profile.
trust
Specify dynamic classification (DSCP) or dot1p to trust.
S4810
Syntax
trust {diffserv [fallback]| dot1p [fallback]}
Parameters
diffserv Enter the keyword diffserv to specify trust of DSCP
markings.
dot1p Enter the keyword dot1p to specify trust dot1p
configuration.
fallback Enter the keyword fallback to classify packets according
to their DSCP value as a secondary option in case no match
occurs against the configured class maps.
Defaults none
Command
Modes
CONFIGURATION (conf-policy-map-in)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.3.1.0 Added fallback to the E-Series.
Version 8.2.1.0 Added dot1p to the C-Series and S-Series.
Quality of Service (QoS)
1381