Dell S4810 - Set Automatic-Tag

Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Usage
Information
You can prepend up to eight AS numbers to a BGP route.
This command influences best path selection in BGP by inserting a tag or AS
number into the AS_PATH attribute.
Related
Commands
match as-path — redistributes routes that match an AS-PATH attribute.
ip as-path access-list — configures an AS-PATH access list.
show ip community-lists — displays configured IP Community access lists.
set automatic-tag
To automatically compute the tag value of the route, configure a filter.
S4810
Syntax
set automatic-tag
To return to the default, enter no set automatic-tag.
Defaults Not configured.
Command
Modes
ROUTE-MAP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Access Control Lists (ACL)
285