Dell S4810 - Dot1 X Max-Eap-Req

Version 8.4.1.0 Introduced on the C-Series and S-Series.
Usage
Information
To disable MAC authentication bypass on a port, enter the no dot1x mac-auth-
bypass command.
dot1x max-eap-req
Configure the maximum number of times an extensive authentication protocol (EAP) request is
transmitted before the session times out.
S4810
Syntax
dot1x max-eap-req number
To return to the default, use the no dot1x max-eap-req command.
Parameters
number Enter the number of times an EAP request is transmitted
before a session time-out. The range is from 1 to 10. The
default is 2.
Defaults 2
Command
Modes
INTERFACE
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version 9.0.0.0 Introduced on the Z9000.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
Version 8.3.11.1 Introduced on the Z9000.
Version 7.6.1.0 Introduced on the C-Series and S-Series.
Version 7.4.1.0 Introduced on the E-Series.
192
802.1X