Dell S4810 - Show Hardware Layer3

Parameters
eg-acl | in-acl Enter either the keyword eg-acl or the keyword in-acl to
select between ingress or egress ACL data.
stack-unit id Enter the keyword stack-unit to select a stack ID. The
range is 0 to 11 for the S4810.
port-set 0–0 Enter the keywords port-set with a port-pipe number. .
The range is 0 for the S4810.
Defaults none
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Usage
Information
The unit numbers given are internal port numbers.
show hardware layer3
Display Layer 3 ACL or QoS data for the selected stack member and stack member port-pipe.
S4810
Syntax
show hardware layer3 {acl | qos} stack-unit number port-set 0–0
Parameters
acl | qos Enter either the keyword acl or the keyword qos to select
between ACL or QoS data.
stack-unit
number
Enter the keywords stack-unit then a number to select a
stack ID. The range is 0 to 11 for the S4810.
port-set 0–0 Enter the keyword port-set with a port-pipe number. The
range is 0 to 0 for the S4810.
Defaults none
Command
Modes
EXEC Privilege
Debugging and Diagnostics
603