Dell S4810 - 18 Fcoe Transit; Clear Fip-Snooping Database Interface Vlan

18
FCoE Transit
To enable the FCoE Transit feature and configure FIP snooping, use the following Dell Networking
Operating System commands on the S4810 platform.
In a converged Ethernet network, a switch can operate as an intermediate Ethernet bridge to snoop on
FIP packets during the login process on Fibre Channel over Ethernet (FCoE) forwarders (FCFs). Acting as a
transit FIP snooping bridge, the switch uses dynamically created access control lists (ACLs) to permit only
authorized FCoE traffic to transmit between an FCoE end-device and an FCF.
clear fip-snooping database interface vlan
Clear FIP snooping information on a VLAN for a specified FCoE MAC address, ENode MAC address, or
FCF MAC address, and remove the corresponding ACLs FIP snooping generates.
S4810
Syntax
clear fip-snooping database interface vlan {vlan-id} enode
{enode-mac-address} | fcf {fcf-mac-address} | session {session-
mac-address}
Parameters
enode-mac-
address
Enter the ENode MAC address to be cleared of FIP snooping
information.
fcf-mac-
address
Enter the FCF MAC address to be cleared of FIP snooping
information.
session-mac-
address
Enter the MAC address for the session to be cleared of FIP
snooping information.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
FCoE Transit
659