Dell S4810 - Show Ip Ospf

Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
Example
Dell(conf-router_ospf)#show config
!
router ospf 3
passive-interface FastEthernet 0/1
Dell(conf-router_ospf)#
show ip ospf
Display information on the OSPF process configured on the switch.
S4810
Syntax
show ip ospf [process-id | vrf vrf name]
Parameters
process-id Enter the OSPF Process ID to show a specific process. If no
Process ID is entered, command applies only to the first
OSPF process.
vrf vrf name Show only the OSPF information tied to the VRF process.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Added support for VRF.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.8.0 Added output for LSA throttling timers.
Version 8.3.7.0 Introduced on the S4810.
Version 7.9.1.0 Added support for VRF.
Version 7.8.1.0 Added support of Multi-Process OSPF.
Version 7.8.1.0 Added the process-id option, in support of Multi-Process
OSPF.
Open Shortest Path First (OSPFv2 and OSPFv3)
1199