Dell S4810 - Ip Redirect-List

• show ip redirect-list – displays the redirect-list configuration.
ip redirect-list
Configure a redirect list and enter REDIRECT-LIST mode.
S4810
Syntax
ip redirect-list redirect-list-name
To remove a redirect list, use the no ip redirect-list command.
Parameters
redirect-list-
name
Enter the name of a redirect list.
Defaults none
Command
Modes
CONFIGURATION
Command
History
Version 9.4.0.0 Introduced on the S4810.
Version 8.4.2.1 Introduced on the C-Series and S-Series.
Version 8.4.2.0 Introduced on the E-Series TeraScale.
Version 6.5.3.0 Introduced on the E-Series ExaScale.
permit
Configure a rule for the redirect list.
S4810
Syntax
permit {ip-protocol-number | protocol-type} {source mask | any
| host ip-address} {destination mask | any | host ip-address}
[bit] [operators]
To remove the rule, use one of the following:
• If you know the filter sequence number, use the no seq sequence-number
syntax command.
• You can also use the no permit {ip-protocol-number | protocol-
type} {source mask | any | host ip-address} {destination
mask | any | host ip-address} [bit] [operators] command.
Policy-based Routing (PBR)
1273