Dell S4810 - Advertise Management-Tlv (Interface)

Version 9.1.
(0.0)
Modified to support management-address parameter.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Introduced on the S-Series.
Version 7.6.1.0 Introduced on the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
Usage
Information
The command options management-address,system-capabilities, system-
description, and system-name can be invoked individually or together, in any
sequence.
advertise management-tlv (Interface)
Advertise management type, length, values (TLVs) to the specified interface.
S4810
Syntax
advertise management-tlv {management-address | system-
capabilities | system-description | system-name}
To remove advertised management TLVs, use the no advertise management-
tlv {management-address | system-capabilities | system-
description | system-name} command.
Parameters
management-
address
Enter the keywords management-address to advertise the
management IP address TLVs to the specified interface.
system-
capabilities
Enter the keywords system-capabilities to advertise the
system capabilities TLVs to the specified interface.
system-
description
Enter the keywords system-description to advertise the
system description TLVs to the specified interface.
system-name Enter the keywords system-name to advertise the system
name TLVs to the specified interface.
Defaults none
Command
Modes
INTERFACE (conf-interface-lldp)
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
1080
Link Layer Discovery Protocol (LLDP)