Dell S4810 - Show Ip Bgp Extcommunity-List

show ip bgp extcommunity-list
View information on all routes with Extended Community attributes.
S4810
Syntax
show ip bgp [vrf vrf-name] [ipv4 unicast] extcommunity-list
[list name]
Parameters
vrf vrf-name (OPTIONAL) Enter the keywords vrf and then the name of
the VRF to view information on all routes with extended
community attributes corresponding to that VRF.
ipv4 unicast (OPTIONAL) Enter the keywords ipv4 unicast to view
information only related to ipv4 unicast routes.
list name Enter the extended community list name you wish to view.
The range is 140 characters.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Added support for VRF.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
To view the total number of COMMUNITY attributes found, use the show ip bgp
summary command. The text line above the route table states the number of
COMMUNITY attributes found.
The show ip bgp community command without any parameters lists BGP
routes with at least one BGP community attribute and the output is the same as for
the show ip bgp command output.
464
Border Gateway Protocol