Dell S4810 - Match Ip Vlan

The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Usage
Information
To access this command, enter the class-map command. After the class map is
identified, you can configure the match criteria.
The match ip precedence command and the match ip dscp command are
mutually exclusive.
Up to eight precedence values can be matched in one match statement. For
example, to indicate the IP precedence values 0 1 2 3, enter either the match ip
precedence 0-3
or match ip precedence 0,1,2,3 command.
NOTE: Only one of the IP precedence values must be a successful match
criterion, not all of the specified IP precedence values must match.
Related
Commands
class-map — identifies the class map.
match ip vlan
Uses a VLAN as the match criterion for an L3 class map.
S4810
Syntax
match ip vlan vlan-id
To remove VLAN as the match criterion, use the no match ip vlan vlan-id
command.
Parameters
vlan vlan-id Enter the keyword vlan and then the ID of the VLAN. The
range is from 1 to 4094.
Defaults none
Command
Modes
CONF-CLASS-MAP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.4.
(0.0)
Introduced on the S-Series and Z-Series.
Quality of Service (QoS)
1353