Dell S4810 - Ip Telnet Vrf

Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.2.1.0 Increased number of VLANs on ExaScale to 4094 (was 2094).
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
E-Series Original command
Related
Commands
telnet — telnet to another device.
ip telnet vrf
Configures a TELNET client to use a specific VRF.
S4810
Syntax
ip telnet [vrf vrf-name]
To undo the TELENT client configuration, use the ip telnet [vrf vrf-name]
command.
Parameters
vrf vrf-name Enter the keyword vrf and then the name of the VRF to
specify the VRF that is used by the TELENT client.
Defaults Disabled
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant FTOS Command Line Reference Guide.
The following is a list of the FTOS version history for this command.
Version 9.4.
(0.0)
Introduced on the S-Series and Z-Series.
Control and Monitoring
115