Dell S4810 - Bgp Fast-External-Fallover; Bgp Four-Octet-As-Support

bgp fast-external-fallover
Enable the fast external fallover feature, which immediately resets the BGP session if a link to a directly
connected external peer fails.
S4810
Syntax
bgp fast-external-fallover
To disable fast external fallover, use the no bgp fast-external-fallover
command.
Defaults Enabled
Command
Modes
ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the S-Series.
Version 7.7.1.0 Introduced on the C-Series.
Usage
Information
The bgp fast-external-fallover command appears in the show config
command output.
The fast external fallover configuration is applied only after you manually reset all
the existing BGP sessions. As a result, after you execute this command, you must
also manually execute the clear ip bgp command in order for the configuration
to take effect.
bgp four-octet-as-support
Enable 4-byte support for the BGP process.
S4810
Syntax
bgp four-octet-as-support
To disable fast external failover, use the no bgp four-octet-as-support
command.
Border Gateway Protocol
395