Dell S4810 User Manual

Parameters
name Enter a text string to associate with one IP address.
ipv6-address Enter the IPv6 address (X:X:X:X::X) to be mapped to the
name.
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant
Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.0.0 Introduced on the Z9000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.7.0 Introduced on the S4810.
Version 8.4.2.1 Introduced on the C-Series and S-Series.
Version 8.4.1.0 Introduced on the E-Series TeraScale.
ipv6 name-server
Enter up to six IPv6 addresses of name servers. The order you enter the addresses determines the order
of their use.
S4810
Syntax
ipv6 name-server ipv6-address [ipv6-address2... ipv6-address6]
To remove a name server, use the no ipv6 name—server ipv6–address
command.
Parameters
ipv6-address Enter the IPv6 address (X:X:X:X::X) of the name server to be
used.
Note: The :: notation specifics successive hexadecimal fields
of zeros.
ipv6-address2...
ipv6-address6
(OPTIONAL) Enter up to five more IPv6 addresses, in the
x:x:x:x::x format, of name servers to be used. Separate the
IPv6 addresses with a space.
Defaults none
932
IPv6 Basics

Dell S4810 Specifications

General

Ports	48 x 10GbE SFP+
Uplink Ports	4 x 40GbE QSFP+
Switching Capacity	1.28 Tbps
Rack Units	1U
Product Type	Switch
Form Factor	Rack-mountable
Power Device	Internal power supply
Power Redundancy	Yes
Operating Temperature	0°C to 40°C
Storage Temperature	-40°C to 70°C
Power Supply	Dual, hot-swappable
MAC Address Table Size	128, 000 entries
Routing Protocol	OSPF, BGP, RIP, PIM, VRRP
Remote Management Protocol	SNMP
Features	VLAN, QoS
Humidity	10% to 90% non-condensing
Dimensions (WxDxH)	43.9 x 46.5 x 4.3 cm