Dell S4810 - 12 Control Plane Policing (Copp); Control-Plane-Cpuqos; Service-Policy Rate-Limit-Cpu-Queues

12
Control Plane Policing (CoPP)
The CoPP commands are supported on the Dell Networking S4810 platform.
control-plane-cpuqos
To manage control-plane traffic, enter control-plane mode and configure the switch.
S4810
Syntax
control-plane-cpuqos
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.8.0 Introduced on the S4810.
service-policy rate-limit-cpu-queues
Apply a policy map for the system to rate limit control traffic on a per-queue basis.
S4810
Syntax
service-policy rate-limit-cpu-queues policy-name
Parameters
policy-name Enter the service-policy name, using a string up to 32
characters.
Control Plane Policing (CoPP)
511