Dell S4810 - Page 510

0 | 1 | IPv4Flow | 102 | 0| Allowed
Dell#
Usage
Information
The following describes the test cam-usage command shown in the Example
below.
Term Explanation
Stack-Unit Lists the stack unit or units that are checked. Entering all
shows the status for all stacks.
Portpipe Lists the portpipe (port-set) or port pipes (port-sets) that are
checked. Entering all shows the status for linecards and
port-pipes in the chassis.
CAM Partition Shows the CAM profile of the CAM.
Available CAM Identifies the amount of CAM space remaining for that
profile.
Estimated CAM
per Port
Estimates the amount of CAM space the listed policy will
require.
Status Indicates whether or not the policy will be allowed in the
CAM.
Example (S-
Series)
FTOS#test cam-usage service-policy input LauraIn stack-unit all
Stack-Unit|Portpipe|CAM Partition|AvailableCAM|EstimatedCAM
per Port|Status
---------------------------------------------------------------
---------
0| 0| IPv4Flow|
102| 0|Allowed
0| 1| IPv4Flow|
102| 0|Allowed
FTOS#
!
FTOS#test cam-usage service-policy input LauraIn
stack-unit 0 port-
set 1
Stack-Unit|Portpipe|CAM Partition|Available CAM|EstimatedCAM
per Port|Status
---------------------------------------------------------------
-----------
0| 1| IPv4Flow|
102| 0|Allowed
FTOS#
510
Content Addressable Memory (CAM)