Dell S4810 - Cam-Acl-Vlan; Clear Line

cam-acl-vlan
Specify the number of VFP blocks allocated to OpenFlow.
S4810
Syntax
cam-acl-vlan vlanopenflow {0|1} vlaniscsi {0|1}
Defaults Disabled.
Parameters
vlanopenflow Enter the number 1 to allocate VFP blocks and enable
OpenFlow.
(Default) Enter the number 0 to disable OpenFlow.
vlaniscsi Enter the number 1 to allocate VFP blocks for iSCSI.
Enter the number 0 to disable iSCSI CAM allocation.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.1.
(0.0)
Introduced on S4810.
Version
8.3.19.0
Introduced on the S4820T.
Usage
Information
Reboot the switch after changing the parameter values for changes to take effect.
For platform-specific instructions about using this command, refer to the SDN
chapter in the Dell Networking OS Configuration Guide.
clear line
Reset a terminal line.
S4810
Syntax
clear line {line-number | aux 0 | console 0 | vty number}
Parameters
line-number Enter a number for one of the 12 terminal lines on the
system. The range is from 0 to 11.
94
Control and Monitoring