Version 7.7.1.0 Introduced on the C-Series.
debug ip bgp
Display all information on BGP, including BGP events, keepalives, notifications, and updates.
S4810
Syntax
debug ip bgp [ vrf vrf-name | ip-address | peer-group peer-
group-name] [in | out]
To disable all BGP debugging, use the no debug ip bgp command.
Parameters
vrf vrf-name Enter the keyword vrf and then the name of the VRF to
debug BGP information corresponding to that VRF.
NOTE: Use this attribute to debug BGP protocol
operations corresponding to either a default or non-
default VRF.
ip-address Enter the IP address of the neighbor in dotted decimal
format.
peer-group
peer-group-
name
Enter the keywords peer-group then the name of the peer
group to debug.
in (OPTIONAL) Enter the keyword in to view only information
on inbound BGP routes.
out (OPTIONAL) Enter the keyword out to view only information
on outbound BGP routes.
A.B.C.D Enter the IP address of peer in the A.B.C.D format.
X:X:X:X::X Enter the IPv6 IP address of peer in the X:X:X:X::X format.
dampening Enter the keyword dampening to view BGP dampening.
events Enter the keyword events to view BGP protocol events.
ipv4 Enter the ipv4 IP address to view the IPV4 route information.
ipv6 Enter the ipv6 IP address to view the IPV6 route information.
keepalives Enter the keyword keepalives to view BGP keepalives.
notifications Enter the keyword notifications to view BGP
notifications.
soft-
reconfiguration
Enter the keywords soft-reconfiguration to view only
information on inbound BGP soft reconfiguration.
updates Enter the keyword updates to view BGP updates.
Border Gateway Protocol
407
To Next Page
Loading...
