16
Equal Cost Multi-Path (ECMP)
Equal cost multi-path (ECMP) is supported on the Dell Networking S4810 platform.
ecmp-group
Provides a mechanism to monitor traffic distribution on an ECMP link bundle. A system log is generated
when the standard deviation of traffic distribution on a member link exceeds a defined threshold.
S4810
Syntax
ecmp-group {ecmp-group-id interface interface | link-bundle-
monitor}
To remove the selected interface, use the ecmp-group no interface
command.
To disable link bundle monitoring, use the ecmp-group no link-bundle-
monitor command.
Parameters
ecmp-group ID Enter the identifier number for the ECMP group. The range is
from 2 to 64.
interface Enter the following keywords and slot/port to add the
interface to the ECMP group:
• 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information
• For a LAG interface, enter the keywords port-channel
then the slot/port information. The range is from 1 to 128.
Defaults Off
Command
Modes
• CONFIGURATION
• CONFIGURATION ECMP-GROUP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Equal Cost Multi-Path (ECMP)
641
To Next Page
Loading...
