Dell S4810 - Private-Vlan Mode

Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Introduced on the C-Series and S-Series.
Related
Commands
private-vlan mode — sets the mode of the selected VLAN to community, isolated,
or primary.
private-vlan mapping secondary-vlan — maps secondary VLANs to the selected
primary VLAN.
show arp — displays the ARP table.
switchport mode private-vlan — sets PVLAN mode of the selected port.
private-vlan mode
Set PVLAN mode of the selected VLAN to community, isolated, or primary.
S4810
Syntax
[no] private-vlan mode {community | isolated | primary}
To remove the PVLAN configuration, use the no private-vlan mode
{community | isolated | primary}
command syntax.
Parameters
community Enter the keyword community to set the VLAN as a
community VLAN.
isolated Enter the keyword isolated to configure the VLAN as an
isolated VLAN.
primary Enter the keyword primary to configure the VLAN as a
primary VLAN.
Defaults none
Command
Modes
INTERFACE VLAN
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Private VLAN (PVLAN)
1319