Dell S4810 - Maximum-Paths; Passive-Interface

Version
8.3.19.0
Introduced on the S4820T.
Version 7.8.1.0 Added support for the C-Series.
Version 7.4.1.0 Introduced on the E-Series.
maximum-paths
Enable the software to forward packets over multiple paths.
S4810
Syntax
maximum-paths number
To disable packet forwarding over multiple paths, use the no maximum-paths
command.
Parameters
number Specify the number of paths. The range is from 1 to 64. The
default is 8 paths.
Defaults 8
Command
Modes
ROUTER OSPF
Command
History
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.8.1.0 Added support for Multi-Process OSPF.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.1
Introduced on the E-Series.
passive-interface
Disable (suppress) sending routing updates on an interface.
S4810
Syntax
passive—interface interface
To enable sending routing updates on an interface, use the no passive-
interface interface command.
Open Shortest Path First (OSPFv2 and OSPFv3)
1257