Dell S4810 - 67 Virtual Router Redundancy Protocol (VRRP)

67
Virtual Router Redundancy Protocol
(VRRP)
Virtual router redundancy protocol (VRRP) is supported by the Dell Networking operating system on the
S4810 platform.
IPv4 VRRP Commands
The following are IPv4 VRRP commands.
advertise-interval
Set the time interval between VRRP advertisements.
S4810
Syntax
advertise-interval seconds
To return to the default settings, use the no advertise-interval command.
Parameters
seconds Enter a number of seconds. The range is from 1 to 255. The
default is 1 second.
Defaults 1 second
Command
Modes
INTERFACE-VRRP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Virtual Router Redundancy Protocol (VRRP)
1739