Dell S4810 - Show Environment

Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series
E-Series Original command.
Example
Dell#show debug
Generic IP:
IP packet debugging is on for
ManagementEthernet 0/0
Port-channel 1-2
Port-channel 5
GigabitEthernet 4/0-3,5-6,10-11,20
GigabitEthernet 5/0-1,5-6,10-11,15,17,19,21
ICMP packet debugging is on for
GigabitEthernet 5/0,2,4,6,8,10,12,14,16
Dell#
show environment
View S-Series and Z-Series system component status (for example, temperature or voltage).
S4810
Syntax
show environment [all | fan | stack-unit unit-id | pem]
Parameters
all Enter the keyword all to view all components.
fan Enter the keyword fan to view information on the fans. The
output of this command is chassis dependent.
stack-unit unit-
id
Enter the keyword stack-unit then the unit-id to display
information on a specific stack member. The range is from 0
to 1.
pem Enter the keyword pem to view only information on power
entry modules.
Command
Modes
• EXEC
• EXEC Privilege
Control and Monitoring
133