Dell S4810 - Ipv6 Unknown-Unicast; Show Cpu-Queue Rate Cp

Usage
Information
Use this command to add the IPv4 catch-all route (0.0.0.0/0) in the LPM route
forwarding table if it was deleted using the no ip unknown-unicast command
previously. This will be the default configuration after reload.
ipv6 unknown-unicast
Disable soft forwarding of unknown IPv6 destination packets.
S4810 MXL Switch
Syntax
[no] ipv6 unknown-unicast
Defaults Soft forwarding is enabled.
Command
Modes
CONFIGURATION
Command
History
Version 9.4(0.0) Introduced on the S4810, S4820T, S6000, Z9000, and MXL
Switch.
Usage
Information
All the default catch-all entries in the longest prefix match (LPM) table collect and
transmit all unresolved IPv6 packets to the CPU, even if they are destined for
unknown destinations.
show cpu-queue rate cp
Display the rates for each CPU queue.
S4810
Syntax
show cpu-queue rate cp
Defaults Not configured.
Command
Modes
EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
514
Control Plane Policing (CoPP)