Dell S4810 - Ip Domain-Name

Dell Networking OS does not support sending DNS queries over a VLAN. DNS
queries are sent out all other interfaces, including the Management port.
To view current bindings, use the show hosts command.
Related
Commands
ip name-server — specifies a DNS server.
show hosts — Views the current bindings.
ip domain-name
Configure one domain name for the switch.
S4810
Syntax
ip domain-name name
To remove the domain name, use the no ip domain-name command.
Parameters
name Enter one domain name to be used to complete unqualified
names (that is, incomplete domain names that cannot be
resolved).
Defaults Not configured.
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
860
IPv4 Routing