Dell S4810 - Show Ip Cam Stack-Unit

27 0 1312
26 0 1312
25 0 1312
24 6 40610
23 0 3932
22 0 2622
21 0 2622
20 0 2622
19 0 2622
18 0 1312
17 0 1312
16 0 3932
15 0 1312
14 0 1312
13 0 1312
12 0 1312
11 0 1312
10 0 1312
9 0 1312
8 0 1312
7 0 1312
6 0 1312
5 0 1312
4 0 1312
3 0 1312
2 0 1312
1 0 1312
0 0 8
Dell#
show ip cam stack-unit
Display CAM entries for an S-Series or Z-Series switch.
S4810
Syntax
show ip cam stack-unit {id} [port-set {pipe-number} | hostname
{ip-address mask [longer-prefixes [ecmp-group detail]]}| ecmp-
group {detail | member-info [detail [group-index index-
number]]}| summary]
Parameters
id Enter the stack-unit ID. The unit ID range is from 0 to 11 for
the S4810.
port-set pipe-
number
Enter the keyword port-set then the number of the stack
unit’s port-pipe.
The unit ID range is from 0 to 0 for the
S4810.
hostname Enter the hostname in A.B.C.D format.
network mask
[longer-
prefixes [ecmp-
group detail]]
(OPTIONAL) Enter the IP address and mask of a route to
CAM entries for that route only. You can enter one of the
following keywords to filter results.
• Enter the keyword longer-prefixes to view routes
with a common prefix.
IPv4 Routing
889