Dell S4810 - Page 890

• Enter the keyword ecmp-group detail to view the
ECMP group index.
ecmp-group
{detail |
member-info
[detail [group-
index index-
number]]}
(OPTIONAL) Enter the keyword ecmp-group then one of the
following keywords to filter results.
• Enter the keyword detail to view the ECMP group
index.
• Enter the keyword member-info to view the member
information for the ECMP group.
• Enter the keyword member-info detail to view
detailed ECMP membership and n-hop information.
• Enter the keyword group-index then the index number
to show ECMP membership per group. The range is from
0 to 1022.
summary (OPTIONAL) Enter the keyword summary to view a table
listing route prefixes and the total number routes which can
be entered in to CAM.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 7.7.1.0 Added support for up to seven stack members.
Version 7.6.1.0 Introduced on the S-Series.
Usage
Information
The following describes the show ip cam command shown in the following
example.
Field Description
Destination Displays the destination route of the index.
EC Displays the number of equal cost multipaths (ECMP)
available for the default route for non-Jumbo line cards. For
Jumbo line cards, displays 0,1 when ECMP is more than
eight.
CG Displays 0.
890
IPv4 Routing