Dell S4810 - Page 891

Field Description
V Displays a 1 if the entry is valid and a 0 otherwise.
C Displays the CPU bit. 1 indicates that a packet hitting this
entry is forwarded to the CP or RP2, depending on Egress
port.
V Id Displays the VLAN ID. If the entry is 0, the entry is not part of
a VLAN.
Mac Addr Displays the next-hop router’s MAC address.
Port Displays the egress interface. Use the second half of the
entry to determine the interface. For example, in the entry
17cl CP, the CP is the pertinent portion.
• CP = control processor
• Gi = Gigabit Ethernet interface
• Te = 10–Gigabit Ethernet interface
Example
Dell#show ip cam stack-unit 0 port-set 0 10.10.10.10/32 longer-
prefixes
Destination EC CG V C VId Mac-Addr Port
----------------- -- -- - ------ --------------------
10.10.10.10 0 0 1 1 0 00:00:00:00:00:00 3f01 CP
Dell#
Usage
Information
The following describes the show ip cam ecmp-group command shown in the
following example.
Field Description
Prefix Length Displays the prefix-length or mask for the IP address
configured on the linecard 0 port pipe 0.
Current Use Displays the number of routes currently configured for the
corresponding prefix or mask on the linecard 0 port pipe 0.
Initial Size Displays the CAM size Dell Networking OS allocates for the
corresponding mask. Dell Networking OS adjusts the CAM
size if the number of routes for the mask exceeds the initial
allocation.
Example
(ECMP-Group)
Dell#show ip cam stack-unit 0 po 0 ecmp-group detail
Destination EC CG V C VId Mac-Addr Port ECMP Group-Index
----------------- -- -- - ----- ---------------- -------------
1.1.1.2 0 0 1 0 0 00:01:e8:8a:d6:58 0004 Te 0/3 -
2.1.1.2 0 0 1 0 0 00:01:e8:8a:d6:58 0009 Te 0/8 -
1.1.1.1 0 0 1 1 0 00:00:00:00:00:00 3f01 CP -
2.1.1.1 0 0 1 1 0 00:00:00:00:00:00 3f01 CP -
1.1.1.0 0 0 1 1 0 00:00:00:00:00:00 3f01 CP -
2.1.1.0 0 0 1 1 0 00:00:00:00:00:00 3f01 CP -
100.1.1. 0 1 0 1 0 0 00:01:e8:8a:d6:58 0004 Te 0/3 0
100.1.1. 0 1 0 1 0 0 00:01:e8:8a:d6:58 0009 Te 0/8 0
IPv4 Routing
891