Dell S4810 - Show Isis Database

show isis database
Display the IS-IS link state database.
S4810
Syntax
show isis database [level-1 | level-2] [local] [detail |
summary] [lspid]
Parameters
level-1 (OPTIONAL) Displays the Level 1 IS-IS link-state database.
level-2 (OPTIONAL) Displays the Level 2 IS-IS link-state database.
local (OPTIONAL) Displays local link-state database information.
detail (OPTIONAL) Detailed link-state database information of each
LSP displays when specified. If not specified, a summary
displays.
summary (OPTIONAL) Summary of link-state database information
displays when specified.
lspid (OPTIONAL) Display only the specified LSP.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.2(0.2) Introduced on the Z9000.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.7.1 Introduced on the S4810.
Usage
Information
The following describes the show isis database command shown in the
following example.
Field Description
IS-IS Level-1/
Level-2 Link State
Database
Displays the IS-IS link state database for Level 1 or Level 2.
LSPID
Displays the LSP identifier.
Intermediate System to Intermediate System (IS-IS)
1017