Dell S4810 - Advertise Dcbx-Appln-Tlv

Defaults Enabled
Command
Modes
PROTOCOL LLDP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version
8.3.12.0
Introduced on the S4810.
Version
8.3.16.0
Introduced on MXL 10/40GbE Switch IO Module.
Usage
Information
You can configure iSCSI TLVs to send either globally or on a specified interface.
The interface configuration takes priority over global configuration.
advertise dcbx-appln-tlv
On a DCBX port with a manual role, configure the application priority TLVs advertised on the interface to
DCBX peers.
S4810
Syntax
advertise dcbx-appln-tlv {fcoe | iscsi}
To remove the application priority TLVs, use the no advertise dcbx-appln-
tlv {fcoe | iscsi} command.
Parameters
{fcoe | iscsi} Enter the application priority TLVs, where:
• fcoe: enables the advertisement of FCoE in application
priority TLVs.
• iscsi: enables the advertisement of iSCSI in application
priority TLVs.
Defaults Application priority TLVs are enabled to advertise FCoE and iSCSI.
Command
Modes
PROTOCOL LLDP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
558
Data Center Bridging (DCB)