Dell S4810 - Load-Balance Hg

The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version
8.3.10.0
Added the ingress-port parameter for the S4810.
Version 8.3.7.0 Introduced on the S4810.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
Usage
Information
By default, Dell Networking OS distributes incoming traffic based on a hash
algorithm using the following criteria:
• IP source address
• IP destination address
• TCP/UDP source port
• TCP/UDP destination port
Related
Commands
hash-algorithm ecmp — changes the hash algorithm across an ECMP.
load-balance hg
Choose the traffic flow parameters the hash calculation uses while distributing the traffic across internal
higig links.
S4810
Syntax
[no] load-balance hg { ip-selection | ipv6-selection [source-ip
| source-ipv6 | source-port-id | source-module-id | dest-ip |
dest-ipv6 | dest-port-id | dest-module-id | protocol | vlan |
L4-source-port | L4-dest-port ] | mac [source-mac | source-
port-id | source-module-id | dest-mac | dest-port-id | dest-
module-id | vlan | ethertype | source-dest-mac ] | tunnel
[ipv4-over-ipv4 | ipv4-over-gre-ipv4 | mac-in-mac]}
IPv4 Routing
877