Dell S4810 - Page 876

dest-mac | source-mac]} | {tcp-udp | ingress-port
[enable]}command.
Parameters
ip-selection
{dest-ip |
source-ip}
Enter the keywords to distribute IP traffic based on the
following criteria:
• dest-ip — Uses destination IP address and destination
port fields to hash. The hashing mechanism returns a 3-
bit index indicating which port the packet should be
forwarded.
• source-ip — Uses source IP address and source port
fields to hash. The hashing mechanism returns a 3-bit
index indicating which port the packet should be
forwarded.
mac {dest-mac
| source-dest-
mac | source-
mac}
Enter the keywords to distribute MAC traffic based on the
following criteria:
• dest-mac — Uses the destination MAC address, VLAN,
Ethertype, source module ID and source port ID fields to
hash. The hashing mechanism returns a 3-bit index
indicating which port the packet should be forwarded.
• source-dest-mac — Uses the destination and source
MAC address, VLAN, Ethertype, source module ID and
source port ID fields to hash. The hashing mechanism
returns a 3-bit index indicating which port the packet
should be forwarded.
• source-mac — Uses the source MAC address, VLAN,
Ethertype, source module ID and source port ID fields to
hash. The hashing mechanism returns a 3-bit index
indicating which port the packet should be forwarded.
tcp-udp enable Enter the keywords to distribute traffic based on the
following:
• enable — Takes the TCP/UDP source and destination
ports into consideration when doing hash computations.
This option is enabled by default.
ingress-port
enable
Enter the keywords to distribute traffic based on the
following:
• enable — Takes the source port into consideration when
doing hash computations. This option is disabled by
default.
Defaults IP 4-tuple (IP SA, IP DA, Source Port, Destination Port)
Command
Modes
CONFIGURATION
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
876
IPv4 Routing