Dell S4810 - Match Ip Route-Source

match route-type — redistributes routes that match a route type.
match tag — redistributes routes that match a specific tag.
match ip route-source
To match based on the routes advertised by routes specified in IP access lists or IP prefix lists, configure a
filter.
S4810
Syntax
match ip route-source {prefix-list prefix-list-name}
To delete a match, use the no match ip route-source {prefix-list
prefix-list-name} command.
Parameters
prefix-list
prefix-list-
name
Enter the keywords prefix-list and then enter the name
of configured prefix list, up to 140 characters.
Defaults Not configured.
Command
Modes
ROUTE-MAP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0 Introduced on the S6000.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810
Version 8.1.1.0 Introduced on the E-Series ExaScale.
Version 7.8.1.0 Increased the name string to accept up to 140 characters.
Prior to 7.8.1.0, names were up to 16 characters long.
Version 7.6.1.0 Introduced on the S-Series.
Version 7.5.1.0 Introduced on the C-Series.
pre-Version
6.1.1.0
Introduced on the E-Series.
Related
Commands
match interface — redistributes routes that match the next-hop interface.
match ip address — redistributes routes that match an IP address.
278
Access Control Lists (ACL)