Dell S4810 - Show Ip As-Path-Access-Lists

pre-Version
6.1.1.0
Introduced on the E-Series.
Usage
Information
To apply the AS-PATH ACL to BGP routes, use the match as-path or neighbor
filter-list commands.
Example
Dell(conf)#ip as-path access-list TestPath
Dell(config-as-path)#
Related
Commands
match as-path — matches on routes contain a specific AS-PATH.
show ip as-path-access-lists
Display the all AS-PATH access lists configured on the E-Series.
S4810
Syntax
show ip as-path-access-lists
Command
Modes
• EXEC
• EXEC Privilege
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
8.3.19.0
Introduced on the S4820T.
Version 8.3.11.1 Introduced on the Z9000.
Version 8.3.7.0 Introduced on the S4810.
Version 8.1.1.0 Introduced on the E-Series ExaScale.
pre-Version
6.1.1.0
Introduced on the E-Series.
Example
Dell#show ip as-path-access-lists
ip as-path access-list 1
permit ^$
permit ^\(.*\)$
deny .*
ip as-path access-list 91
permit ^$
deny .*
permit ^\(.*\)$
Dell#
Access Control Lists (ACL)
299